Home Decorators Collection 51422 Installation Guide download pdf (Page 10)

Assembly - Attaching the Fan Blades

Mounting the fan Close-to-Ceiling mounting

□ Align the locking slots of the ceiling canopy (C) with the two

screws in the mounting bracket (A). Push up to engage the

slots, and turn clockwise to lock the canopy (C) in place.

□ Firmly tighten the two mounting screws.

□ Install the remaining two mounting screws (HH) and washers

(WW) into the holes in the canopy (C) and tighten rmly.

□ Install the canopy ring (D) by aligning the ring’s slots with

screws in the canopy (C). Rotate the ring clockwise to lock in

place.

WARNING: When using the standard ball/downrod mounting, the

tab in the ring at the bottom of the mounting bracket must rest in

the groove of the hanger ball. Failure to properly seat the tab in

the groove could cause damage to the wiring.

WARNING: The locking slots of the ceiling canopy are provided only

as an aid to mounting. Do not leave the fan assembly unattended

until all four canopy screws are engaged and rmly tightened.

□ Carefully unhook the fan from the mounting bracket (A) and

align the locking slots of the ceiling canopy (C) with the two

screws in the mounting bracket (A). Push up to engage the

slots and turn clockwise to lock the canopy (C) in place. Im-

mediately tighten the two mounting screws rmly.

□ Install the remaining two mounting screws (HH) and washers

(WW) into the holes in the canopy (C) and tighten rmly.

□ Install the canopy ring (D) by aligning the ring’s slots with

screws in the canopy (C). Rotate the ring clockwise to lock in

place.

Assembly - Hanging the Fan (continued)

Attaching the blade brackets

□ Fasten the blade bracket (I) to the motor (F) by inserting the

alignment post into the slot on the bottom of the fan-motor

assembly (F) and tightening the motor screws that are pre-

assembled to the blade bracket (I).

□ Repeat for the remaining four blade brackets (I).

□ Insert the rubber plug (EE) into the hole in the switch cup (UU).

IMPORTANT: Insert the rubber plug (EE) to prevent water from

entering the switch housing and to reduce the risk of re,

electric shock, or other personal injury.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Home Decorators Collection 51422 Installation Guide Page 10