USE AND CARE GUIDEBENTLEY III 22 INCH CEILING FANItem #XXX XXXModel #AL14-22-BN Questions, problems, missing parts? Before returning to the store, ca
Assembly — Hanging the Fan (continued)107Preparing the receiver andremote controlWARNING: To avoid possible electrical shock, be sure electricity is t
Making the electrical connectionsAssembly — Hanging the Fan (continued)11HOMEDEPOT.COM/HOMEDECORATORSPlease contact 1-800-986-3460 for further assista
9Installing the canopyAssembly — Hanging the Fan (continued)BCCLLCBCCANNC1210Attaching the canopy bottom cover to the canopyCC□ Tuck the connectio
Disassembling Your FanThis fan comes with a pre-assembled the rear guard (G), blade (H), and front guard (I) for your easy installation. Check that al
OperationREMOTE CONTROL OPERATING INSTRUCTIONSREMOTE CONTROL OPERATING INSTRUCTIONSINSTALLING THE REMOTE CONTROL HOLDERINSTALLING THE REMOTE CONTROL H
Care and CleaningTroubleshooting DoDoProblemProblemSolutionSolution□ Use water when cleaning. Water could damage the motor, or the wood, or possib
Service Parts PartPartABCDEFGHIJKLDescriptionDescriptionMounting bracket (preassembled)CanopyCanopy bottom cover (preassembled)Hanger ball/downrod ass
AL14-22-BN00001-AQuestions, problems, missing parts? Before returning to the store,call Home Decorators Collection Customer Service8 a.m. - 7 p.m., ES
Table of Contents ...Safety Information ...
Safety Information 3 HOMEDEPOT.COM/HOMEDECORATORSPlease contact 1-800-986-3460 for further assistance.WARNING: To reduce the risk of electrical shock
SPECIFICATIONSSPECIFICATIONSTOOLS REQUIREDTOOLS REQUIREDPhillips screwdriverElectrical tapeWire stripperFlat blade screwdriverStep ladderWarranty4Pre-
AABBCCDDEEFFGGHHIIJJKKLLMMCollar setscrew (preassembled)Plastic wire nut (not to scale)Canopy mounting bracket screw (preassembled)Remote control hold
PartPartGHIJKLDescriptionDescriptionRear guard (preassembled)Blade (preassembled)Front guard (preassembled)ReceiverRemote controlRemote control holde
To hang your fan where there is an existing fixture but no ceiling joist, you may need an installation hanger bar (OO) (not included) as shown above.
1Preparing the canopy2Preparing the motor□ Remove the canopy bottom cover (C) from the canopy (B) by turning the canopy bottom cover (C) counter-
4Installing the mounting bracket to the electrical boxHanging the fan from the mounting bracket□ Pass the 120-volt supply wires through the cente
Comments to this Manuals