Home Decorators Collection 51528 Use and Care Manual download pdf (Page 9)

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

Hanging the fan

□ Pass the 120-Volt supply wires through the center hole in the

slide-on mounting bracket (A).

□ Install the ceiling slide-on mounting bracket (A) on the outlet box

by sliding the slide-on mounting bracket (A) over the two screws

(II) provided with the outlet box. If necessary, use leveling washers

(not included) between the slide-on mounting bracket (A) and

the outlet box. Note that the at side of the slide-on mounting

bracket (A) is toward the outlet box.

□ Securely tighten the two mounting screws (II).

□ Carefully lift the fan-motor assembly (E) up to the slide-on

mounting bracket (A).

□ Seat the hanger ball portion of the ball/downrod assembly (B)

in the mounting bracket socket. Ensure that the tab on the

slide-on mounting bracket (A) socket is properly seated in the

groove in the hanger ball.

1 2

WARNING: To reduce the risk of re, electric shock, or other

personal injury, mount the fan to an outlet box or supporting

system marked “Acceptable for fan support of 35 lbs.

(15.9kg) or less” and use the mounting screws provided

with the outlet box.

WARNING: The hook as shown is only to balance the fan

while attaching wiring. Failure to hang as shown may

result in hook breaking, causing the fan to fall. The hook

must pass from inside to the outside of the canopy (C).

NOTE: The frequencies on your receiver and hand unit have

been preset at the factory. Before installing the receiver,

make sure the dip switches on the receiver and hand unit are

set to the same frequency. The dip switches on the hand unit

are located inside the battery compartment.

NOTE: The switch marked ON/DIM controls the dimming

function of the lights: If using CFL bulbs, use a ballpoint pen

or small screwdriver to set the switch to ON to disable the

dimming function. If using standard bulbs, set the switch to

DIM to enable the dimming function.

Setting the code on the remote control and receiver

□ Remove the remote control (L) battery cover by pressing

rmly on the arrow and sliding the cover off.

□ Slide the dip switches to your choice of either up or down.

The factory setting is up.

□ Slide the dip switches (JJ) on the receiver (K) to the same

position as set on the remote control (L).

□ Replace the battery cover on the remote control (L).

1 2

DIM

12V 23A

DIP

1 2 3

DIP

1 2 3 4

DIM

DIP

NOTE: The battery will weaken with age and should be

replaced before leaking takes place as this will damage the

hand unit. Dispose of used battery properly and keep the

battery out of the reach of children.

NOTE: The mounting bracket (A) is designed to slide into place

on an outlet box with the outlet box screws (II).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Home Decorators Collection 51528 Use and Care Manual Page 9

Comments to this Manuals

Related products and manuals for Household fans Home Decorators Collection 51528